16-Port Gigabit Ethernet Xpim (Poe); Figure 10: 16-Port Gigabit Ethernet With Poe Xpim - Juniper SRX550 Hardware Manual

16-Port Gigabit Ethernet XPIM (PoE)

Copyright © 2016, Juniper Networks, Inc.
SRX550 High Memory Services Gateway Mini-Physical Interface Modules Overview
on page 31
1-Port Serial Mini-Physical (SRX-MP-1SERIAL-R) Interface Module on page 32
1-Port T1/E1 Mini-Physical (SRX-MP-1T1E1-R) Interface Module on page 34
The 16-Port Gigabit Ethernet XPIM is a double-high, single-wide LAN switch
Gigabit-Backplane Physical Interface Module (GPIM) that uses two standard slots
vertically. It is available with or without Power over Ethernet (PoE) support. The SRX550
High Memory Services Gateway supports the PoE model. The PoE GPIMs provide ports
that supply electric power over the same ports that are used to connect network devices.
The 16-Port Gigabit Ethernet XPIM must be installed in one of the following 20-Gigabit
slots on the SRX550 High Memory Services Gateway:
Slot 3
Slot 6
NOTE: The 16-Port Gigabit Ethernet XPIM is supported on both slot 3 and
slot 6 of the SRX550 High Memory Services Gateway. However, the
performance (bandwidth) in slot 3 will be limited as it has a 10G back link.
NOTE: The SRX550 High Memory Services Gateway does not support
hot-swappable functionality for GPIMs.

Figure 10: 16-Port Gigabit Ethernet with PoE XPIM

The 16-Port Gigabit Ethernet XPIM has the following key features:
16 triple-speed (10/100/1000 Mbps) Ethernet ports, single-high card
PoE support for all ports
PCI-Express interface for control and management
I2C interface for module monitor and identification
Chapter 3: Interface Module Description
29