Rj-45 Connector Pin Assignments; Ac Power Supply; Installing An Ac Power Supply - Avaya 8200 Installing Manual

Installing the Avaya Virtual Services Platform 8200
4. If the transceiver does not slide easily from the port, use a gentle side-to-side rocking motion
while firmly pulling the transceiver from the port.
5. Attach a dust cover over the fiber-optic bores and store the transceiver in a safe place until
you need it.
Important:
Discard transceivers in accordance with the proper laws and regulations.

RJ-45 connector pin assignments

The following section describes the pin assignments for the RJ-45 connectors in the Avaya Virtual
Services Platform 8200. The Console port (10101) and Management port both use RJ-45
connectors.
Table 9: RJ–45 port pin assignments
Connector

AC power supply

Installing an AC power supply

Important:
Avaya does not support installing a combination of AC-input and DC-input power supplies in the
same chassis.
The VSP 8284XSQ supports two field-replaceable 800W power supplies. One comes with the
switch and you can install a second power supply to provide redundancy and load sharing.
Installing the Avaya VSP 8200
38
Pin Number Signal
1 Ready to send (RTS) — optional
2 Data terminal ready (DTR) — optional, can swap or link with pin
8
3 Transmit data (TXD) — mandatory
4 Carrier detect (DCD) — optional
5 Ground (GND) — mandatory
6 Receive data (RXD) — mandatory
7 Data set ready (DSR) — optional
8 Clear to send (CTS) — optional, can swap or link with pin 1
Comments? infodev@avaya.com
December 2014