Chapter 4: Ac Power Supply Installation For The Vsp 9010 Ac Chassis - Avaya Virtual Services Platform 9010 Manual

Chapter 4: AC power supply installation for
This chapter describes the procedures to install AC power supplies in the Avaya Virtual Services
Platform 9010 AC chassis. The Virtual Services Platform 9010 AC chassis provides eight slots for
power supplies.
You need qualified service personnel to install and replace Virtual Services Platform 9000
components.
Before you begin
Voltage:
Risk of injury by electric shock
Before working on this equipment, be aware of proper safety practices and the hazards involved
with electrical circuits. Use only power cords that have a grounding path. Ensure the switch is
properly grounded before powering on the unit.
About this task
For information about the minimum software version required to support the hardware, see Release
Notes for Avaya Virtual Services Platform 9000, NN46250-401.
Important:
Avaya recommends that you install each power supply on its own dedicated branch circuit for
electrical installation reasons.
The following table lists the estimated time to install an AC power supply for the Virtual Services
Platform 9010 AC. The installation time depends on the number of power supplies you are installing.
Table 3: Estimated time
Task
Removing the air inlet cover
Installing the AC power supply
The Virtual Services Platform 9010 chassis ships with no installed power supplies. In the front of the
chassis, power supply slots are numbered increasing from left to right, with 1, 2, 3, and 4 on the first
row, and then 5, 6, 7, and 8 on the second row. Install the first power supply in the top-left slot.
December 2014
the VSP 9010 AC chassis
Comments? infodev@avaya.com
Estimated Time
Less than 1 minute
1 minute
Installing AC Power Supplies in Avaya VSP 9000
13