Table of Contents
Advertisement
Installing the server and connecting the peripheral devices
To connect the server to power
1. Plug the server's AC power cord into the server's rear panel.
2. Plug the other end into a wall receptacle or power bar.
To start the server
1. Press the server power switch to start the server.
2. Observe the Power-On Self Test (POST) and initialization messages on the monitor.
3. Let the mini-setup sequence run until you are prompted to log in to the operating
4. Ensure that the operating system logon window appears on the monitor.
5. Proceed with the CallPilot server and switch configuration guide for your switch to
48
Avaya CallPilot® 703t Server Hardware Installation
system.
Note:
The system may perform multiple reboots. This is normal.
Note:
If the logon window does not appear, refer to the CallPilot Maintenance and
Diagnostics guide for your server for troubleshooting instructions.
connect and configure the server and switch.
December 2010
Advertisement
Table of Contents
