Using The Operator Panel; Table 3.1 Definitions Of Mode Switch Positions - Fujitsu PRIMEPOWER850 User Manual

Table 3.1
Function
Operation state
Break input
Alive check by POST/OBP
Alive check by OS
Power on and Power on and off with
off (Note 1) power switch
Power on and off from
F7973RC1 (Note 2)
Power on and off by auto-
matic power supply control
Note 1: Auto boot: When the main switch is turned on, the Solaris operating
Boot stop: When the main switch is turned on, the system enters OBP
Note 2: Only Japanese systems
At the above power-off times, the shutdown sequence starts if the operating system is
on. Power is turned off after the shutdown sequence is completed.
3.2.2.3

Using the operator panel

This section explains how to use the operator panel.
(1) Display format of operator panel LCD
The operator panel has a two-line status display LCD.
Figure 3.4
U41261-J-Z816-4-76
defines each mode switch position on the operator panel.

Table 3.1 Definitions of mode switch positions

environment starts up automatically.
mode and stops. The Solaris operating environment does not
start up.
shows the format of the status display LCD.
3.2 Names and Functions of Components
Mode switch
LOCK
Normal Maintenance
(software)
Disabled Enabled
Enabled Enabled
Enabled Disabled
Only power on Enabled
enabled (auto boot) (boot stop)
Enabled Enabled
(auto boot) (boot stop)
Enabled Enabled
(auto boot) (boot stop)
MAINTENA
UNLOCK
NCE
Maintenance
(hardware)
Enabled
Enabled
Disabled
Enabled
(boot stop)
Disabled
Disabled
59