Fujitsu PRIMEPOWER850 User Manual page 50

CHAPTER 2 PRIMEPOWER650 Rack-mount Type (8U) Server
l Installation of the PRIMEPOWER650 rack-mount type (8U) server should be such
that the amount of air flow required for safe operation is not compromised.
- The PRIMEPOWER650 rack-mount type (8U) server has ventilation openings
at the front and back faces of the unit.
- To prevent overheating, do not cover or close these ventilation openings.
l Mounting of the PRIMEPOWER650 rack-mount type (8U) server in the rack
should not cause an unbalanced load. To maintain the stability of the entire rack,
please fix the rack to the wall or floor by suitable means.
- Be careful of injuries during installation of the PRIMEPOWER650 rack-mount
type (8U) server into the rack.
- Do not install the PRIMEPOWER650 rack-mount type (8U) server into a rack
if the server unit may make the entire rack unstable.
- Maximum configured weight of this unit: 85 kg (187.4 lb.)
l If the PRIMEPOWER650 rack-mount type (8U) server is supplied with power
from a power strip or service outlet of other units, it may overload the power
supply cord or the power strip of other units.
- Confirm that the current rating of the power strip or service outlet exceeds the
combined ratings of all equipment it is supplying.
- Electrical ratings of this unit: 100-120 to 200-240VAC, 7.7A to 5.8A per power
cable, 50/60Hz, single-phase.
l Reliable earth grounding of rack-mounted equipment should be maintained. If
indirect power connections (e.g. via power strips) are used, earth grounding is
necessary.
Equipment damage
Connect the ground before connecting any of the power supply lines. If all of the
power cables are connected to a single power strip, high leakage current exceeding
the stipulated value may leak through to the earth lead of the power strip.
If the power strip is not directly connected to the main distribution panel, use a power
strip with an industrial plug.
20 U41261-J-Z816-4-76