Fujitsu PRIMEPOWER850 User Manual page 17

Task
Normal
operation
U41261-J-Z816-4-76
Warning
Equipment damage
Use care when handling hard disk drives. Takes
the precautions listed below to minimize the risk
of accidental damage while handling the disk
drive. If these precautions are not observed the
hard disk drive could be damaged or lose data.
l Do not subject the unit to excessive impact.
l Do not bring the unit near to equipment (motors,
speakers, etc.) that generate strong magnetic
fields.
l Do not store the unit in locations likely to cause
condensation inside the unit or in locations
subject to sudden changes in temperature or
humidity.
Media damage
Pay attention to the following when handling any
CD-ROM / DVD-ROM disc. If these precautions
are not observed the disc may be damaged or
lose data.
l Do not scratching the surface of a CD-ROM /
DVD-ROM disc. Pay special attention when
removing a CD-ROM / DVD-ROM disc from its
case.
l Do not widening the center hole of a CD-ROM /
DVD-ROM disc.
l Do not writing on a CD-ROM / DVD-ROM disc
label with a ball-point pen or pencil.
l Do not cleaning a CD-ROM / DVD-ROM disc with
benzene, paint thinner, water, record spray, or an
antistatic agent.
l Do not exposing a CD-ROM / DVD-ROM disc to
heat or sunlight.
l Do not storing a CD-ROM / DVD-ROM disc in a
place that undergoes rapid changes in
temperature or humidity.
Data destruction
Do not press the Eject button during operation
(when the tape LED is blinking). If the Eject
button is held down for about five seconds, the
forced ejection function will execute, and any
data being written may be lost.
Equipment damage/Data destruction
Put only recommended data cartridges in the
data cartridge slot. Any other type of foreign
object may damage the unit or cause data to be
lost.
FOR SAFE OPERATION
Page
110
113
117
117
ix