Table of Contents
Advertisement
Check Date and Time
N O T E
Perform a Mainframe
Timebase Adjustment
Perform a Touch
Screen Alignment
Run Scan Disk 86100A/
B
1 On the DCA screen, click Help and About 86100A(or B).
2 On the DCA front panel, press the Local hardkey 5 times (until Service Mode enabled is
3 On the DCA screen, click Utilities, Service, Exit Scope.
4 On the DCA screen, click Start, Programs, Accessories, System Tools, Scan Disk.
5 Select Standard Test and click Start.
6 If there are any errors after the completion of the test, select Repair the Errors and press OK.
7 Close the dialog boxes and cycle power.
Run Disk Scan 86100C Disk error checking on Windows XP:
1 On the DCA click Exit on the File menu to close the 86100C application.
2 When asked "are you sure you want to exit 86100C", click Yes.
3 Click START
4 Click My Computer
5 Click INFINIIUM drive (C:)
6 Select File Properties
7 Click Tools, Check Now...
8 Select Options, Start.
General Information
Preventative Maintenance, 86100A/B/C
Preventative Maintenance, 86100A/B/C
The following steps should be checked or performed at the yearly calibration interval.
Refer to the On-Line Help for instructions on resetting the date and time.
If the date and time setting do not remain after it is set, the battery on the A4 PC Motherboard
assembly may need to be replaced.
For users who need "As Received" or "Pre Cal" data at the yearly calibration interval, a verifica-
tion process must be done first. Otherwise, a yearly Horizontal Timebase Adjustment is recom-
mended before performance verification is started.
Refer to "Touchscreen Calibration" on page
Scan Disk will check the files and folders of the selected drive for any errors, lost clusters, lost
chains, and bad sectors.
displayed).
1-12
Refer to "To Replace the Batteries" on page
Refer to "Timebase Adjustment" on page
3-9.
7-13.
3-3.
Advertisement
Chapters
Table of Contents
