Agilent Technologies Infinium DCA 86100A Service Manual page 150

Replacing Instrument Assemblies
To Replace the A1 Power Supply
4 Disconnect all cables from the power supply.
N O T E You may need to remove the cable from the A9P2 Hard Drive connector on the A15 Disk Drive
Interface to access cables on the A4 PC Motherboard.
5 Rout the cables out of the instrument when you are removing the A2 Power Supply.
6 Refer to
7 To re-install the power supply, perform the above steps in the reverse order.
Figure 7-22. A12P2 Connection
Figure 7-23. Fan Connections
7-18
Figure 7-22 through Figure 7-24 for cable connections.
A12P2
Connection