Agilent Technologies Infinium DCA 86100A Service Manual page 119

28 Install tie wraps around W33/W1 and W35 as shown in
Figure 6-8. Tie Wrapping the Cables
N O T E The tie wrap should be installed after the cables are connected.
29 Check that all connections are secure and that all newly installed cables are routed through
existing chassis cable ties.
To add new Touch Screen Controller drivers and remove the old ones
N O T E Make sure that the new hardware is installed before continuing with this software installation.
30 Connect a keyboard and mouse to the DCA.
31 Turn on the instrument.
32 After the DCA is booted, exit the DCA application by clicking File, Exit.
N O T E When the "Found New Hardware" message appears for the new touchscreen -- before you install
the touch screen drivers -- simply cancel the dialog and continue with the software installation as
described below.
N O T E You may also see "Found New Hardware" message for the 82350B GPIB PCI card. Just accept
the new hardware.
33 Download the new drivers from the following web site:
http://lwd.marketing.agilent.com/Service_Support/Product_Support/86100/infiniiumdca.htm
N O T E To get the new touch screen drivers, use a PC connected to the network and unzip the files into a
USB memory stick
34 Download MT7.11.2Win32.zip from the support web site.
35 Unzip the file into a USB memory stick or other temporary memory location.
36 Connect the memory stick to the DCA's USB port.
37 Using Windows Explorer on the DCA, open the directory where the unzipped files are located.
38 Double-click Setup.exe to install the new Touch Screen Controller drivers in the DCA.
39 Follow the instructions to install the MT 7.11 SR2 software. Accept the terms of the license
agreement.
40 Remove the old drivers: click START. Select Control Panel then Add Remove Programs.
41 Locate the Universal Pointer Device Driver and remove it from the DCA.
Instrument Modifications
Replacing A7A2, A8, or A9 Assemblies
Figure 6-8.
6-9