Ls-120 Disc Drive Modification - Agilent Technologies Infinium DCA 86100A Service Manual

LS-120 Disc Drive Modification

1 Follow the instructions for removing the instrument cover, on page 7-3.
2 Place the instrument so the top is facing up.
3 Using a T-10 TORX driver, remove the two screws that secure the A16 LS-120 board to the rear
of the A10 floppy drive. Refer to
4 Remove the ribbon cable, W9 and the board assembly. Refer to
Figure 6-18. LS-120 and A-10 Floppy Drive
5 Modify the A16 LS-120 board by installing a ground strap from pin 2 to the mounting hole. Refer
to Figure 6-19.
Figure 6-19. A16 LS-120 Board shown with Added Ground Strap
Figure 6-18.
Instrument Modifications
LS-120 Disc Drive Modification
Figure 6-18.
6-19