Agilent Technologies Infinium DCA 86100A Service Manual page 136

Replacing Instrument Assemblies
To Remove the Instrument Cover
Figure 7-2. Removing the Rubber Feet
4 Remove the remaining four screws that fasten the cover to the instrument's rear panel, as shown
in Figure 7-3.
Figure 7-3. Removing Screws from Back of Mainframe
5 Remove the two screws that secure each handle to the side of the mainframe, as shown in
7-4.
6 Remove the hole plug on the bottom of the frame to avoid damaging the plug.
7-4
Figure