To Replace The A1 Power Supply - Agilent Technologies Infinium DCA 86100A Service Manual

To Replace the A1 Power Supply

WA R N I N G The following label warns you about hazardous voltages present on the A1 power supply. Use
extreme caution. Disconnect the instrument from all voltages before it is opened.
1 Follow the instructions for removing the mainframe cover, on page 7-3.
2 Use a T-15 TORX driver to remove the two screws that secure the mainframe to the top of the A1
Power Supply, as shown in
Figure 7-20. Removing the Screws Securing the Power Supply
3 Remove the two screws located on either side of the hard drive, as shown in
Figure 7-21. Removing the Screws on Top of the Hard Drive
Figure 7-20.
Replacing Instrument Assemblies

To Replace the A1 Power Supply

Figure 7-21.
7-17