Install The License File - Avaya DEFINITY Server R Manual

Upgrading Release 9/10r to Avaya DEFINITY Server R
running Avaya MultiVantage Software
7. Type reset spe-standby 4.
This will get the new software load running on the stand-by processor.
8. Type status spe.
9. Repeat until both processor states of health are functional and standby
processor shows:

Install the License File

Pre-installation
1. Type save translation and press
After the translations have been copied (about 10 minutes), the system
returns an error code, which must be a zero; otherwise, the translations are
not copied.
2. Type reset system 3 and press
Wait until the system has completely reset before continuing.
3. If the system has IP endpoints registered, unplug the Ethernet cable from
the TN799 (C-LAN) circuit pack.
This disconnects (unregisters) all IP endpoints.
4. Type set time and press
Ensure that the system date and time are set correctly.
Installation (direct connection)
If you have a direct connection between the RFA and the switch:
1. Go to the RFA website, and, following the instructions in the "Deliver to
G3r/G3si/G3csi" chapter of the RFA Job Aid, deliver the License File.
2. If the system has IP endpoints registered, and you unplugged the Ethernet
cable from the TN799 (C-LAN) circuit pack, replug the cable.
This re-registers the IP endpoints.
1-22
Issue 5 October 2002
handshake=on
shadowing=on
refresh=yes
Enter
NOTE:
This procedure sends the License File to the switch and installs it.
.
Enter
.
Enter
.
555-233-115