Add Memory, Replace Dupint Circuit Pack, And Unseat Disk Drive On; Power Up Spe B (High/Critical Reliability Only) - Avaya DEFINITY Server R Manual

Upgrading G3rV4 and R5/6/7/8r to Avaya DEFINITY
Server R running Avaya MultiVantage Software
Add Memory, Replace DUPINT Circuit Pack, and
Unseat Disk Drive on SPE B
(High/Critical reliability only)
NOTE:
The vintages on the various TN1650Bs do not have to match. They can be
vintage 1 or later.
1. Insert the TN1650B memory circuit pack(s) (any vintage) in memory slot(s)
3 (if needed) and 4.
2. Check the label on the UN330B DUPINT circuit pack. If it is Vintage 3 or
later, go to step 6.
3. Remove the old UN330B DUPINT circuit pack and place it in antistatic
packing material.
!
CAUTION:
THE FOLLOWING STEPS ARE EXTREMELY CRITICAL.
4. Set the SPE SELECT switch on the V3 or later DUPINT circuit pack to be
in the same position as the circuit pack just removed. Because you are
placing it in carrier B, the SPE SELECT switch must be set to A, the active
carrier.
5. Insert the new UN330B DUPINT circuit pack into the slot vacated by the
old one.
6. Unseat the TN1657 disk drive so SPE B boots from the optical drive.

Power Up SPE B (High/Critical reliability only)

1. If there are two power supplies, restore power to the SPE by inserting the
power plug on the right side of the carrier then by inserting the power plug
on the left side of the carrier. If there is only one power supply, insert the
one power plug on the right side.
If high or critical reliability:
2. Monitor the SPE as it reboots by observing the LEDs and the terminal. It is
powered up when the YELLOW LED on the UN331B/C Processor circuit
pack flashes and other LEDs go out, which takes about 10 minutes.
2-38
Issue 5 October 2002
NOTE:
The disk drive must be unlocked and moved out because the carrier
must boot from the Avaya MultiVantage Software on removable
media.
555-233-115