Locking the Cutting-Unit Pivot for Cutting Grass on a Hill
Side
Lock the cutting-unit pivots with snapper pins
prevent the cutting units from rotating downhill
when cutting across the face of a hill.
Note:
the cutting unit.
Note:
unit.
Installing the Cutting Unit Lift-Arm Chains
Secure the lift-arm chain
with the snapper pin
Note:
in the cutting unit Operator's Manual.
Installing the Reel Motors
1. Grease the reel-motor spline shaft.
2. Oil the reel motor O-ring and install it onto the motor flange.
3. Install the motor
Setup: Installing the Cutting Units
Use the hole
in the pivot yoke to lock
Use the slot
for a steering cutting
to the chain bracket
.
Use the number of chain links described
by rotating it clockwise so that the motor flanges clear the bolts
to
G437965
G402673
Page 3–10
.
3464-482 A