Omron SYSMAC CS Series Operation Manual page 71

Wiring
Hook
3. When soldering, take care not to short the terminal to the neighboring one.
Cover the soldered part with an insulating tube.
Note Be sure to check that the output power supply is not connected in reverse.
4. Assemble the connector (included or purchased separately) as shown be-
low. The shape of the 40-pin connector is different to that shown in the di-
agram.
Connector cover
Socket
Nuts (3)
After wiring
Soldered-type connector
included with Unit
Insulating tube
2
Wire (0.2 to 0.13 mm )
Small screws (3)
Small screws (2)
Connector lock screw
Cable clamp
Nuts (2)
Section 3-3
Remove the label.
51