Omron SYSMAC CS Series Operation Manual page 104

Unit Setup Area
Address Bits
DM 6632 00 to 15 Ring set value for pulse output
counter 2
DM 6633 00 to 15
Settings for Analog Inputs/Outputs (CS1W-HCA22-V1/HCA12-V1 Only)
Address Bits
DM6612 00 to 07 Analog input
DM 6613 00 to 07 Analog output 1
08 to 15
DM 6614 00 to 07 Analog output 2
08 to 15
Address Bits
DM 6630 00 to 07 For both analog out-
puts 1 and 2
08 to 15 Analog inputs
DM 6631 00 to 15 For both analog out-
puts 1 and 2
DM 6632 00 to 15 (Reserved by sys-
to tem.)
DM 6643
84
Function
Settings Enabled at Startup
Function
Analog input range
Output signal range
Operation when output turned OFF
Output signal range
Operation when output turned OFF
Settings Enabled at Startup and when Operation Starts
Function
Analog output
refresh method
Analog input refresh
method
Adjustment mode
password
---
Details
Rightmost 4 digits
Leftmost 4 digits
Details
00Hex: -10 to +10 V
01Hex: 0 to 10 V
02Hex: 1 to 5 V (4 to 20 mA)
03Hex: 0 to 5 V
00 Hex: –10 to 10 V
01 Hex: 0 to 10 V
02 Hex: 1 to 5 V
03 Hex: 0 to 5 V
5A Hex: Output disabled (See note.)
Note: Setting 5A can be used to
shorten the I/O refresh time.
00 Hex: Cleared
01 Hex: Held
02 Hex: Peak value
Same as for analog output 1.
Details
00 Hex: END refresh (The values stored in AR 14
and AR 15 are output as analog signals after execu-
tion of the END instruction.)
01 Hex: Immediate refresh using instructions (Ana-
log signal output with execution of SPED or ACC
instruction. Output values are stored in AR 14 and
AR 15 for monitoring.)
00 Hex: END refresh
01 Hex: Immediate refresh using PRV instruction
5A5A Hex: Adjustment mode enabled
Setting other than 5A5A: Adjustment mode disabled
Section 5-1
Same as for ring set value for
pulse output counter 1.