Omron SYSMAC CS Series Operation Manual page 177

Analog Input Functions
Address Bits Function
AR 18 00 Adjustment mode
command (valid
when DM6631 =
5A5A Hex)
01
02
03
06
07
08
15
Details
Analog Adjust- ON: Adjustment invalid
Input/Ana- ment
OFF: Adjustment valid
log Output 1 enable
At the rise of this bit, an initial
Analog Out-
value (offset or gain) corre-
put 2
sponding to I/O signal ranges
is transferred to AR 19/20
(adjustment value monitor
bits).
Analog Adjust- OFF: Offset adjustment
Input/Ana- ment
ON: Gain adjustment
log Output mode
1/2 specifi-
cation
Analog Adjust OFF: Analog output
Input/Ana- object
ON: Analog input
log Output 1 specifi-
cation
Analog Adjust- OFF to ON: the data is put
Input/Ana- ment back to the factory default set-
log Output value ting.
1/2 clear (to
default
data)
Analog Adjust- OFF to ON: the value in 16-bit
Input/Ana- ment resolution of AR 19/20
log output 1/ value (adjustment value monitor
2 set (reg- bits) is stored in Flash mem-
istra- ory. The value is used in the
tion) next operation.
Analog Adjust- This is turned ON by faulty
Input/Ana- ing operations. (Ex: Turning ON
log output 1/ opera- both adjustment enable flags
2 tion for analog input and output at
error the same time, etc)
Analog Start- Stays ON in adjustment
Input/Ana- ing mode. (when DM6631 = 5A5A
log Output adjust- Hex)
1/2 ment
mode
Section 7-9
Controlled Forced
by set/reset
User Enabled
Unit
157