Ladder Library Function; Special Auxiliary Bit; Applicable Models; Overview - Omron SYSMAC CS Series Operation Manual

Ladder Library Function

Cycle Time
Constant cycle
time value
Constant Cycle Time Exceeded
SR 24905
CONSTANT CYCLE TIME OVER clear
SR 25207

7-11-3 Special Auxiliary Bit

Address Bits
SR 252 07 CONSTANT CYCLE TIME OVER clear
0 to 1: CONSTANT CYCLE TIME OVER clear

7-12 Ladder Library Function

7-12-1 Applicable Models

7-12-2 Overview

166
The function is canceled
The fixed cycle time
Function
Model numbers
CS1W-HIO01-V1 12 contact inputs, 8 contact outputs
CS1W-HCP22-V1 12 contact inputs, 8 contact outputs, 2 pulse inputs, 2 pulse outputs
CS1W-HCA22-V1 12 contact inputs, 8 contact outputs, 2 pulse inputs, 2 analog outputs
CS1W-HCA12-V1 12 contact inputs, 8 contact outputs, 1 analog input, 1 pulse input, 2 analog
outputs
These units can encapsulate an entire program or partial programs to save it
to the Flash memory in the unit. This function is called "Ladder library func-
tion".
The encapsulated program is called a "Ladder library".
With this function, either "partial programs (subroutine program group)" or an
"entire ladder program" can be encapsulated as a ladder library.
The encapsulated program "ladder library" can be executed in the following 2
modes:
MCRO Mode
In this mode, partial programs (subroutine program group) is read and exe-
cuted as a "ladder library", that is to say, treated as if it is an applied instruc-
tion in the main program.
Boot Mode
In this mode, an entire ladder program is read at starting an operation and
executed as a "ladder library".
The constant cycle time function will be valid again.
The actual cycle time
ON during 1 scan
Functions
Section 7-12
Time
Controlled by
User