Omron SYSMAC CS Series Operation Manual page 135

AR Area
Address Bits
AR 16 00 Analog Output 1 Con-
version Enable Bit
01 Analog Output 2 Con-
version Enable Bit
02 to 15 (Reserved by system.)
AR 17 00 Analog Output 1 User
Adjustment Flag
01 Analog Output 2 User
Adjustment Flag
02 to 03 (Reserved by system.)
04 Analog Output 1
Operation In Progress
05 Analog Output 2
Operation In Progress
06 to 07 (Reserved by system.)
08 Analog Output 1 Out-
put SV Error
09 Analog Output 2 Out-
put SV Error
10 to 11 (Reserved by system.)
12 Analog Output 1 Fac-
tory Setting Adjust-
ment Error
13 Analog Output 2 Fac-
tory Setting Adjust-
ment Error
14 Analog Output 1 User
Adjustment Error
15 Analog Output 2 User
Adjustment Error
Function
ON: D/A conversion enabled (an analog signal is
output)
OFF: D/A conversion is not performed (analog out-
put is held at the value specified in DM 6613 and
DM 6614)
Note: These bits are cleared when the Customiz-
able Counter Unit's operating mode is switched
between RUN or MONITOR mode and PROGRAM
mode.
The default setting is OFF. When offset/gain adjust-
ment is performed by the user, these bits turn ON,
and when the adjustment values are cleared and
reset to their factory settings these bits return to
OFF.
ON: Analog output is being changed using the
ACC instruction.
OFF: Analog output has reached the target value.
ON: A value that exceeds the allowable range has
been set for analog output SV.
OFF: The values set for analog output SV lie within
the allowable range.
Note: This bit is valid only when the analog output
method is set to END refresh.
ON: There is an error in the factory-set data stored
in FROM.
OFF: There are no errors in the factory-set data
stored in FROM.
ON: There is an error in a user adjustment value
stored in FROM.
OFF: There are no errors in the user adjustment
values stored in FROM.
Details
Section 6-4
Controlled Forced
by set/reset
User Enabled
--- ---
Unit Enabled
115