Omron SYSMAC CS Series Operation Manual page 100

Unit Setup Area
Settings Enabled at Startup and when Operation Starts
Address Bits
DM 6615 00 to 15 Enable high-speed execution
DM 6616 00 to 15 (Reserved by system.)
DM 6617 00 to 15 Peripheral port servicing time
DM 6618 00 to 15 Cycle monitor time
DM 6619 00 to 15 Constant cycle time
DM 6620 00 to 03 Interrupt input 0 (IR 00000)
function
04 to 07 Interrupt input 1 (IR 00001)
function
08 to 11 Interrupt input 2 (IR 00002)
function
12 to 15 Interrupt input 3 (IR 00003)
function
DM 6621 00 to 15 (Reserved by system.)
to
DM 6623
DM6624 00 to 15 Ladder library execution mode Specify either "Boot mode execution" where a ladder library
-V1 only
( )
DM6625 00 to 15 Ladder library ID (4 digits)
-V1 only
( )
DM6626 00 to 15 Ladder library name
-V1 only
( )
DM6627 00 to 15
-V1 only
( )
DM6628 00 to 15
-V1 only
( )
DM6629 00 to 15
-V1 only
( )
DM 6630 00 to 15 Special I/O Setup Area
to
DM 6639
DM 6640 00 to 15 (Reserved by system.)
to
DM 6644
80
Function
Setting other than 5A5A Hex: Normal Execution Mode
5A5A: High-speed Execution Mode
---
0000 (BCD): Default (0.2 ms)
0001 to 0500 (BCD): Sets peripheral port servicing time in the
range 0.1 to 50.0 ms (0.1-ms units).
0000 (BCD): Default (50 ms)
0001 to 0100 (BCD): Sets cycle monitor time in the range 1 to
100 ms (in 1-ms units).
Note: If the cycle monitor time is exceeded, a system error
(fatal error; error code: 9F), is generated.
0000 (BCD): Variable cycle time
0001 to 0500 (BCD): Sets a constant cycle time in the range
0.1 to 50.0 ms (in 1-ms units). (Even if all the necessary pro-
cessing is completed in less than the set time, the next cycle
will not start until the constant cycle time setting has elapsed.)
Note: If the constant cycle time setting is exceeded, SR 24905
turns ON.
0 Hex: Normal input
1 Hex: Interrupt input for ON
2 Hex: Interrupt input for OFF
3 Hex: Interrupt input for ON
and OFF
---
stored in the Flash is opened and executed at starting an oper-
ation, or "execution with MCRO instruction" where a ladder
library is called by MCRO subroutine and used.
Other than 5A5A, A5A5: Ladder library not used
5A5A Hex: Boot mode
A5A5 Hex: Execution with MCRO instruction
0000 to FFFF Hex
At creating a ladder library, the ID code of the library is stored in
the Flash memory.
Arbitrary 16-digit hexadecimal code (8 characters in ASCII). At
creating a ladder library, the name of the library is stored in the
Flash memory.
---
---
Section 5-1
Contents
Note: Settings 1 to 3 Hex are
valid in both Interrupt Input
Mode and Counter Mode.