Omron SYSMAC CS Series Operation Manual page 136

AR Area
Address Bits
AR 18 00 Adjustment mode
command (valid when
DM6631 = 5A5A Hex)
01
02
03
04
05
06
07
08
09 to 14
15
116
Function
Analog
Input/Ana-
log Output 1
Analog Out-
put 2
Analog
Input/Ana-
log Output 1/
2
Analog
Input/Ana-
log Output 1
Analog Out-
put 1/2
Analog Out-
put 1/2
Analog
Input/Ana-
log Output 1/
2
Analog
Input/Ana-
log output 1/
2
Analog
Input/Ana-
log output 1/
2
(Reserved by system.)
Analog
Input/Ana-
log Output 1/
2
Details
Adjust- ON: Adjustment invalid
ment
OFF: Adjustment valid
enable
At the rise of this bit, an ini-
tial value (offset or gain)
corresponding to I/O signal
ranges is transferred to AR
19/20 (adjustment value
monitor bits).
Adjust- OFF: Offset adjustment
ment
ON: Gain adjustment
mode
specifi-
cation
Adjust OFF: Analog output
object
ON: Analog input
specifi-
cation
Adjust- While this bit is ON, the off-
ment set value or the gain value
up bit increases by 1 (resolution)
at every 0.5 s.
Adjust- While this bit is ON, the off-
ment set value or the gain value
down decreases by 1 (resolu-
bit tion) at every 0.5 s.
Adjust- OFF to ON: the data is put
ment back to the factory default
value setting.
clear
(to
default
data)
Adjust- OFF to ON: the value in 16-
ment bit resolution of AR 19/20
value (adjustment value monitor
set bits) is stored in Flash
(regis- memory. The value is used
tration) in the next operation.
Adjust- This is turned ON by faulty
ing operations. (Ex: Turning
opera- ON both adjustment enable
tion flags for analog input and
error output at the same time,
etc)
Start- Stays ON in adjustment
ing mode. (when DM6631 =
adjust- 5A5A Hex)
ment
mode
Section 6-4
Controlled Forced
by set/reset
User Enabled
Unit