Omron SYSMAC CS Series Operation Manual page 127

AR Area
Address Bits
AR 20 00 to 15 Pulse output 1 monitor
data
AR 21 00 to 15
AR 22 00 to 15 Pulse output 2 monitor
data
AR 23 00 to 15
Analog Outputs (CS1WHCA22-V1/HCA12-V1 Only)
Address Bits
AR 14 00 to 15 Analog Output 1 Out-
put Value
AR 15 00 to 15 Analog Output 2 Out-
put Value
Function
Range compari-
son result
Output bit pattern The output bit pattern
Range compari-
son result
Output bit pattern
Function
If END refresh is set as the analog output
method, the value set here by the user in 4-
digit hexadecimal is output from analog out-
put 1 when analog output is refreshed.
If immediate refresh using instructions is set
as the analog output method, the value out-
put from analog output port 1 is stored here
in 4-digit hexadecimal for monitoring when
analog output is refreshed.
0 to 10 V, 0 to 5 V, 1 to 5 V:
–10 to 10 V:
Note 1: The analog output method (END
refresh or immediate refresh using instruc-
tions) is specified in bits 00 to 07 of DM 6630
in the Unit Setup Area (00 Hex: END refresh-
ing). The setting applies to both analog out-
puts 1 and 2.
Note 2: The output signal range is specified
in DM 6613.
Same as above (except that analog output 2
is used for analog output and the output sig-
nal range is set in DM 6614).
Details
The instruction execu-
tion result that is output
when the CTBL instruc-
tion is executed for a
range comparison is
stored here.
Bits 00 to 15: ON for
each condition (from 1 to
16) that is satisfied.
OFF: Condition not sat-
isfied
ON: Condition satisfied
that is output when the
CTBL instruction is exe-
cuted for a range com-
parison is stored here.
Note: When more than
one condition is satis-
fied, the logical OR of all
the output patterns for
satisfied conditions is
set.
Same as for pulse output
1 monitor data.
Details
FF38 to 1068 Hex
EA84 to 157C Hex
Section 6-4
Controlled Forced
by set/reset
Unit Enabled
Controlled Forced
by set/reset
Immediate Enabled
refresh
using
instructions:
Unit
END
refresh:
User
107