Omron SYSMAC CS Series Operation Manual page 70

Wiring
Connectors
Recommended Wire Size
Wiring Method
1,2,3...
50
6. Do not pull on cables. Doing so may result in disconnection.
7. Do not bend cables beyond their natural limit. Doing so may result in dis-
connection.
Connections to the I/O Connector
Connector type
Soldered
(See note.)
Crimp
Pressure welded
Note A soldered connector is provided with the Unit.
Connections to the Special I/O Connector
Connector type
Soldered
(See note.)
Crimp
Pressure welded
Note A soldered connector is provided with the Unit.
Applicable Connector Terminal Conversion Units
Connecting Cable
XW2Z-@@@B
XW2Z-@@@BU
The recommended size for cable wires is AWG 24 to 26 (0.2 to 0.13 mm
Use a cable with an outer diameter of less than 1.61 mm.
1. Check that all the Units are mounted securely.
Note Ensure that pressure is not exerted on cables.
2. To prevent the wire cuttings that are scattered during wiring from entering
the interior of the Unit, leave the label attached to the top of the Unit when
performing wiring. After wiring has been completed, remove the label to al-
low proper heat dissipation.
Number of pins Ordering as a
set (OMRON)
24 pins C500-CE241
24 pins C500-CE242
24 pins C500-CE243
Number of pins Ordering as a
set (OMRON)
40 pins C500-CE404
40 pins C500-CE405
40 pins C500-CE403
Connector– Number of pins
Terminal
Conversion Unit
XW2D-40G6 40 pins
XW2B-40G5
XW2B-40G4
XW2D-40C6
Section 3-3
Ordering individually
(Fujitsu)
Socket: FCN-361J024-AU
Connector cover:
FCN-360C024-J2
Housing: FCN-363J024
Connector cover:
FCN-360C024-J2
Contact: FCN-363J-AU
FCN-367J024-AU/F
Ordering individually
(Fujitsu)
Socket: FCN-361J040-AU
Connector cover:
FCN-360C040-J2
Socket: FCN-363J040
Connector cover:
FCN-360C040-J2
Contact: FCN-363J-AU
FCN-367J040-AU
Size
Miniature
Standard
Standard
Miniature
2
).