Omron SYSMAC CS Series Operation Manual page 160

Analog Outputs
Note
WDT error in Customizable Counter Unit
Flash memory adjustment data error (flash mem-
ory error and adjustment data error indicated in AR
Area) or CPU standby error in CPU Unit
Any other fatal error for Customizable Counter Unit
(flash memory errors not listed above, FALS, etc.
Specified Output Values and Analog Output Signals
−10 to 10 V
Analog output signal
+11.0 V
+10.0 V
0.0 V
−10.0 V
−11.0 V
0000
EC78
Resolution: 10,000
EA84
0 to 5 V
Analog output signal
5.25 V
5.0 V
0.0 V
−0.25 V
0000
Resolution: 4,000
FF38
140
1. Accuracy applies to full scale.
2. Analog outputs are treated as described in the following table for fatal er-
rors in the Customizable Counter Unit or CPU standby status for the CPU
Unit.
Condition
If there is an error in the settings for the analog outputs in the User Setup Area
(DM 6613, DM 6614, DM 6630, and DM 6631), the following status will be
used.
Output signal range:
Output hold function:
Refresh method:
0 to 10 V
Analog output signal
Specified output value
(4-digit Hex)
1388
157C
Specified output value
0FA0
(4-digit Hex)
1068
Analog output
Output near 0 V (0 V if no offset is set).
The output status specified for the hold function
(clear, peak, or hold) will be output.
– 10 to 10 V
Clear
END refresh
10.5 V
10.0 V
0.0 V
−0.5 V
0000
Resolution: 4,000
FF38
1 to 5 V
Analog output signal
5.2 V
5.0 V
1.0 V
0.8 V
0000
Resolution: 4,000
FF38
Section 7-7
Specified output value
(4-digit Hex)
0FA0
1068
Specified output value
0FA0
(4-digit Hex)
1068