Verifying that the primary controller identifies the new LSP and has sent the translations
Verifying that the primary controller identifies the new LSP
and has sent the translations
To verify that the new S8500 LSP has registered with, and has received translations from, the
primary controller, perform the following steps:
1. Wait several minutes after resetting the S8500 LSP, then on the primary controller, use the
SAT command list survivable-processor to verify that the LSP server registers
and translations are updated.
If the LSP has registered, the Service State? field shows in-service and the Translations
Updated field shows the time and date.
Figure 8: List Local Survivable Processor screen
list survivable-processor
Name
LSPNYC
LSPCHI
Readministering media gateways to point to the LSP
Change the controller list for each G700, G350, or G250 media gateway that will use the LSP as
an alternate controller. This enables the media gateway to seek service from the LSP if the
connection to the primary controller fails.
For instructions on changing the media gateway's controller list, see one of the following
documents:
Installation and Upgrades for the Avaya G700 Media Gateway and Avaya S8300 Media
●
Server, 555-234-100
Installation and Upgrades for the Avaya G250 Media Gateways, 03-300434
●
Installation and Upgrades for the Avaya G350 Media Gateway, 03-300394
●
Installing and Configuring the Avaya S8500 Media Server
SURVIVABLE PROCESSORS
Type
ID
IP Address
LSP
04
128.256.173.101
LSP
05
128.256.113.213
Page
Service
Translations
State?
Updated
in-service/idle
03:21 02/19/03
out-of-service
February 2006
1 of
xx
04:32 02/20/03
81