• Set the power-on password.
• Reconfigure the server.
See "Using the Setup Utility" on page 51 for details.
Removing the SD adapter
Use this information to remove the SD adapter.
To remove the SD adapter, complete the following steps:
Step 1.
Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2.
Remove the top cover (see "Removing the top cover" on page 162).
Step 3.
Remove the riser-card assembly 2, if needed (See "Removing a riser-card assembly" on page 198).
Step 4.
Loosen two screws.
Step 5.
Lift the SD adapter out of the server.
Step 6.
Remove the SD cards.
SD adapter
1
Figure 216. SD adapter removal
Step 7.
If you are instructed to return the SD adapter, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.
Replacing the SD adapter
Use this information to replace a SD adapter.
Important: If your SD adapter option comes with VMware vSphere ESXi software preloaded, you must
make configuration changes to your system UEFI before installing the SD adapter in your compute node. See
the documentation that comes with the SD adapter and "Using the Setup Utility" on page 51 for information
and instructions.
3
1
Chapter 5
4
.
Installing, removing, and replacing components
269