Removing The Fan Cage Assembly - Lenovo System x3650 M5 Installation And Service Manual

Hide thumbs Also See for System x3650 M5:

Table of Contents

Figure 109. DIMM installation

Touch the static-protective package that contains the DIMM to any unpainted metal surface on the

outside of the server. Then, remove the DIMM from the package.

Turn the DIMM so that the alignment slot align correctly with the alignment tab.

Insert the DIMM into the connector by aligning the edges of the DIMM with the slots at the ends of

the DIMM connector (see "System-board optional-device connectors" on page 32 for the locations

of the DIMM connectors).

Firmly press the DIMM straight down into the connector by applying pressure on both ends of the

DIMM simultaneously. The retaining clips snap into the locked position when the DIMM is firmly

seated in the connector.

Note: If there is a gap between the DIMM and the retaining clips, the DIMM has not been correctly

inserted; open the retaining clips, remove the DIMM, and then reinsert it.

Step 10. Reconnect the power cords and any cables that you removed.

Step 11. Replace the air baffle (see "Replacing the air baffle" on page 166).

Note: Close all the retaining clips even for slots without DIMMs installed before replacing the air

Step 12. Replace the top cover (see "Replacing the top cover" on page 164).

Step 13. Turn on the peripheral devices and the server.

Removing the fan cage assembly

Use this information to remove the fan cage assembly.

To replace some components or to create working room, you might have to remove the fan cage assembly.

Note: To remove or install a fan, it is not necessary to remove the fan cage. See "Removing a hot-swap fan"

on page 192 and "Replacing a hot-swap fan" on page 193.

To remove the fan cage assembly, complete the following steps:

Lenovo System x3650 M5 Installation and Service Guide