Removing A Riser-Card Assembly - Lenovo System x3650 M5 Installation And Service Manual

Step 9. Reconnect the power cords and any cables that you removed.
Step 10. Turn on the peripheral devices and the server.

Removing a riser-card assembly

Use this information to remove a riser-card assembly.
See
http://www.lenovo.com/ serverproven/
To remove a riser-card assembly, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines" on
page 305.
Step 2. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
Step 3. Remove the top cover (see "Removing the top cover" on page 162).
Step 4. Grasp the blue touch-points on the front and the rear side of the riser-card assembly; then, lift it up
to remove it from the server. Place the riser-card assembly on a flat, static-protective surface.
• For half-length and low profile adapters
Figure 120. Riser-card assembly removal - half-length and low profile adapters
• For full-height, full-length adapters
198
Lenovo System x3650 M5 Installation and Service Guide
for a list of riser-card assemblies that you can use with the server.
PCI riser-card
assembly 2
PCI riser-card
assembly 1