Lenovo System x3650 M5 Installation And Service Manual page 70

The IPv6 link-local address (LLA) is derived from the IMM default host name. The IMM LLA is on the IMM
network access tag is on the power supply on the rear of the server. To derive the link-local address,
complete the following steps:
Step 1. Take the last 12 characters on the IMM MAC address (for example, 5CF3FC5EAAD0).
Step 2. Separate the number into pairs of hexadecimal characters (for example, 5C:F3:FC:5E:AA:D0).
Step 3. Separate the first six and last six hexadecimal characters.
Step 4. Add "FF" and "FE" in the middle of the 12 characters (for example, 5C F3 FC FF FE 5E AA D0).
Step 5. Convert the first pair of hexadecimal characters to binary (for example, 5=0101, C=1100, which
results in 01011100 F3 FC FF FE 5E AA D0).
Step 6. Flip the 7th binary character from left (0 to 1 or 1 to 0), which results in 01011110 F3 FF FE 5E AA
D0.
Step 7. Convert the binary back to hexadecimal (for example, 5E F3FCFFFE5EAAD0).
Obtaining the IP address for the IMM
Use this information to obtain the IP address for the IMM.
To access the web interface to use the remote presence feature, you need the IP address or host name of
the IMM. You can obtain the IMM IP address through the Setup Utility and you can obtain the IMM host
name from the IMM network access tag. The server comes with a default IP address for the IMM of
192.168.70.125.
To obtain the IP address, complete the following steps:
Step 1. Turn on the server.
Note: Approximately 5 seconds after the server is connected to power, the power-control button
becomes active.
When the prompt <F1> Setup is displayed, press F1. (This prompt is displayed on the screen for
Step 2.
only a few seconds. You must press F1 quickly.) If you have set both a power-on password and an
administrator password, you must type the administrator password to access the full Setup Utility
menu.
Step 3. From the Setup Utility main menu, select System Settings.
Step 4. On the next screen, select Integrated Management Module.
Step 5. On the next screen, select Network Configuration.
Step 6. Find the IP address and write it down.
Step 7. Exit from the Setup Utility.
Logging in to the Web interface
To log in to the IMM2 Web interface, do the following:
Step 1. On a system that is connected to the server, open a Web browser. In the Address or URL field,
type the IP address or host name of the IMM2 to which you want to connect.
Note: If you are logging on to the IMM2 for the first time after installation, the IMM2 defaults to
DHCP. If a DHCP host is not available, the IMM2 assigns a static IP address of 192.168.70.125.
The IMM2 network access tag provides the default host name of the IMM2 and does not require
you to start the server.
58
Lenovo System x3650 M5 Installation and Service Guide