Installing A 8X 3.5-Inch Simple-Swap Hdd Serveraid Assembly Kit - Lenovo System x3650 M5 Installation And Service Manual

Hide thumbs Also See for System x3650 M5:

Table of Contents

Power / configuration

Figure 273. 8x2.5-inch simple-swap hard disk drive with hardware RAID cabling

Replace the fan cage assembly and fans if you removed them (see "Replacing the fan cage

assembly" on page 191 and "Replacing a hot-swap fan" on page 193).

Step 10. Reinstall the hard disk drives (see "Replacing a hot-swap hard disk drive" on page 172).

Step 11. Install the top cover (see "Replacing the top cover" on page 164).

Step 12. Slide the server into the rack.

Step 13. Reconnect the power cords and any cables that you removed.

Step 14. Turn on the peripheral devices and the server.

Installing a 8x 3.5-inch simple-swap HDD ServeRAID assembly kit

Use this information to install a 8x 3.5-inch simple-swap HDD ServeRAID assembly kit.

You can install a Lenovo System x3650 M5 8x 3.5-inch simple-swap HDD ServeRAID assembly kit to

support eight 3.5-inch simple-swap hard disk drive model in the server. See

for a list of supported optional devices. To order a 8x 3.5-inch hot-swap HDD assembly kit,

serverproven/

contact your sales representative or reseller.

The 8x 3.5-inch simple-swap HDD ServeRAID assembly kit contains one simple-swap backplate assembly

with two cables attached.

To install a 8x 3.5-inch hot-swap HDD assembly kit, complete the following steps:

SAS signal cable

http://www.lenovo.com/

Installing, removing, and replacing components