Removing An Eia Assembly - Lenovo System x3650 M5 Installation And Service Manual

Hide thumbs Also See for System x3650 M5:

Table of Contents

– Connect to the 3.5-inch HDD hot-swap backplane with 12 HDDs from the rear hard drive

3.5" hard disk drive cage

Figure 156. 3.5-inch rear two hard-disk-drive kit cable routing

Press down the HDD kit firmly until the HDD kit is fully seated in the connector on the system

Replace the top cover (see "Replacing the top cover" on page 164).

Slide the server into the rack.

Reconnect the power cords and any cables that you removed.

Step 10. Turn on the peripheral devices and the server.

Removing an EIA assembly

Use the following instructions to remove an EIA assembly for 2.5-inch and 3.5-inch models.

Note: The EIA assembly is available only on some models.

2.5-inch model

There are the right EIA assembly and the left EIA assembly on the server, use the following steps to remove

SAS signal cable

Installing, removing, and replacing components