Replacing A Hot-Swap Hard Disk Drive - Lenovo System x3650 M5 Installation And Service Manual

To remove a hot-swap hard disk drive, complete the following steps.
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2. Make sure you save the data on your drive, especially if it is part of a RAID array, before you remove
it from the server.
Step 3. Slide the latch to unlock the drive handle.
2.5-inch hot-swap
hard disk drive
Latch
Handle
Figure 89. 2.5-inch hot-swap hard disk drives removal
3.5-inch hot-swap
hard disk drive
Latch
Figure 90. 3.5-inch hot-swap hard disk drives removal
Step 4. Grasp the handle and slide the drive out of the drive bay.
Step 5. Reinstall the drive bay filler panel.
Step 6. If you are instructed to return the drive assembly, follow all packaging instructions, and use any
packaging materials for shipping that are supplied to you.

Replacing a hot-swap hard disk drive

Use this information to install a hot-swap hard disk drive.
The following notes describe the type of hard disk drives that the server supports and other information that
you must consider when you install a hard disk drive. For a list of supported hard disk drives, see
www.lenovo.com/ serverproven/
• Locate the documentation that comes with the hard disk drive and follow those instructions in addition to
the instructions in this chapter.
172
Lenovo System x3650 M5 Installation and Service Guide
Handle
.
http://