Lenovo System x3650 M5 Installation And Service Manual page 216

Slot 1
Slot 2
Slot 3
Figure 127. PCI riser-card adapter expansion slot locations
2.5-inch rear two
hard-disk-drive kit Slot 4
Figure 128. PCI riser-card adapter expansion slot locations
The following table describes the maximal card dimension supported in each slot.
Table 15. The maximal card dimension supported in each slot
Riser-card assembly
Riser-card assembly 1
Riser-card assembly 2
Note: If you are replacing a high power graphics adapter, you might need to disconnect the internal power
cable from the system board before removing the adapter.
To remove an adapter, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2. Turn off the server and peripheral devices and disconnect all power cords; then, remove the top
cover (see "Removing the top cover" on page 162).
Step 3. Remove the riser-card assembly that contains the adapter (see "Removing a riser-card assembly"
on page 198).
• If you are removing an adapter from PCI expansion slot 1, 2, or 3, remove riser-card assembly 1.
• If you are removing an adapter from PCI expansion slot 6, 7 or 8, remove riser-card assembly 2.
Step 4. Disconnect any cables from the adapter (make note of the cable routing, in case you reinstall the
adapter later).
204
Lenovo System x3650 M5 Installation and Service Guide
Slot 4 Slot 5
3.5-inch rear two
Slot 5 hard-disk-drive kit
Slot number
1
2
3
4
5
6
7
8
3.5-inch rear two
hard-disk-drive kit
The maximal card dimension supported
Full height, up to full length
Full height, up to full length
Full height, half length
Low-profile
Low-profile
Full height, up to full length
Full height, up to full length
Full height, half length