Table of Contents
Advertisement
PCI riser assembly
Figure 46. Adapter installation
Step 5.
Tighten the screw.
Step 6.
Reconnect the cables to the adapter that you removed earlier.
Step 7.
Reinstall the PCI riser-card assembly (see "Replacing the PCI riser-card assembly" on page 123).
Attention: When you install an adapter, make sure that the adapter is correctly seated in the PCI
riser-card assembly and that the PCI riser-card assembly is securely seated in the riser-card
connector on the system board before you turn on the server. An incorrectly seated adapter might
cause damage to the system board, the PCI riser-card assembly, or the adapter.
Step 8.
Reinstall compute node (see "Installing a compute node in a chassis" on page 82).
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect any cables that you removed.
3. Turn on the peripheral devices and the server.
Note: If the server is configured for RAID operation through an optional RAID adapter, you might have to
reconfigure your disk arrays after you install an adapter.
Removing an HBA adapter
Use this information to remove an HBA adapter.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
If you are replacing a server component or installing an optional device in the server, you need to take out the
node out from the rack enclosure, turn off the server and peripheral devices, and disconnect all external
cables.
To remove an HBA adapter, complete the following steps.
Step 1.
Remove the compute node (see "Removing a compute node from a chassis" on page 81).
Step 2.
Remove the air baffle (see "Removing the air baffle" on page 90).
Step 3.
Remove the HBA screws (x4).
116
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
Adapter
Screw
Expansion-slot filler
Advertisement
Table of Contents
Troubleshooting
