Lenovo System x3650 M5 Installation And Service Manual page 232

Hide thumbs Also See for System x3650 M5:

Table of Contents

Figure 148. Two 2.5-inch rear two hard-disk-drive kits numbering

• 3.5-inch hot-swap hard disk drive model

– One 2.5-inch rear two hard-disk-drive kit numbering

Figure 149. One 2.5-inch rear two hard-disk-drive kit numbering

– One 3.5-inch rear two hard-disk-drive kit (with or without RAID card) numbering

Figure 150. One 3.5-inch rear two hard-disk-drive kit (with or without RAID card) numbering

– One 3.5-inch and one 2.5-inch rear two hard-disk-drive kits numbering

Figure 151. One 3.5-inch and one 2.5-inch rear two hard-disk-drive kits numbering

To install the rear two hard-disk-drive kit, complete the following steps:

Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page

Turn off the server and peripheral devices and disconnect all power cords.

Remove the top cover (see "Removing the top cover" on page 162).

Align the rear two hard-disk-drive kit with the connector on the system board and align it with the

slots on the chassis; then, lower it into the server and press down firmly until the rear two hard-

disk-drive kit is seated correctly in the connector on the system board

• 2.5-inch rear two hard-disk-drive kit installation

Lenovo System x3650 M5 Installation and Service Guide

SATA/SAS hard disk drive bays

Troubleshooting