Lenovo System x3650 M5 Installation And Service Manual page 241

5. Disconnect the front USB/operator information panel cables from the connector mounted on the chassis
side wall.
Note: Disengage all latches, release tabs or locks on cable connectors when you disconnect all cables
from the system board. Failing to release them before removing the cables will damage the cable
sockets on the system board. The cable sockets on the system board are fragile. Any damage to the
cable sockets may require replacing the system board.
Figure 166. Front USB/operator information panel cable removal
6. Loosen screws and remove them.
Screws
Figure 167. Screw removal
7. To remove the cable cover, angle the cable cover as shown in the following illustration and slide the
cable cover slightly towards the rear side of the server to remove it from the server.
Front USB / operator
information panel cable
.
Chapter 5 Installing, removing, and replacing components
229