Lenovo System x3650 M5 Installation And Service Manual page 258

CAUTION:
The power control button on the device and the power switch on the power supply do not turn off the
electrical current supplied to the device. The device also might have more than one power cord. To
remove all electrical current from the device, ensure that all power cords are disconnected from the
power source.
Statement 8
CAUTION:
Never remove the cover on a power supply or any part that has the following label attached.
Hazardous voltage, current, and energy levels are present inside any component that has this label
attached. There are no serviceable parts inside these components. If you suspect a problem with one
of these parts, contact a service technician.
To remove a hot-swap ac power supply, complete the following steps:
Step 1. Read the safety information that begins on "Safety" on page v and "Installation guidelines" on page
305.
Step 2. If only one power supply is installed, turn off the server and peripheral devices and disconnect all
power cords.
Step 3. If the server is in a rack, at the back of the server, pull back the cable management arm to gain
access to the rear of the server and the power supply.
Step 4. Press and hold the release tab to the left. Grasp the handle and pull the power supply out of the
server.
246
Lenovo System x3650 M5 Installation and Service Guide