Table of Contents
Advertisement
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
Attention: The server automatically powers off when the air baffle is removed.
To remove the air baffle, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Step 2.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 49).
Step 3.
Remove the air baffle from the server by press the release latches and set it aside.
Release latch
Figure 38. Air baffle removal
Removing the fan cage assembly
Use this information to remove the fan cage assembly from the server.
Read the safety information in "Safety" on page v and "Installation guidelines" on page 29.
If you are replacing a server component in the server, you need to turn off the server and peripheral devices,
and disconnect the power cords and all external cables.
To remove the fan cage assembly, complete the following steps.
Step 1.
Carefully turn the server on its side so that it is lying flat, with the cover facing up.
Attention: Do not allow the server to fall over.
Step 2.
Unlock and remove the left-side cover (see "Removing the left-side cover" on page 49).
Air baffle
Release latch
.
Chapter 2
Installing optional devices
51
Advertisement
Table of Contents
Troubleshooting
