Table of Contents
Advertisement
For information on encryption and decryption of archives sent as an attachment, see section
E-mail (Page 120).
4.11
Maintenance
4.11.1
Configuration
In this tab you can save the configuration data of the RTU in a configuration file and load it
again.
Configuration files have the file format *.cfg
Note
RTU3010C and RTU3030C not compatible
Note that configurations of RTU3010C and RTU3030C are not compatible.
Configuration
Load configuration
With this function a configuration file created previously and saved on the PC is loaded on
the RTU.
● File
After selecting a configuration file stored on the configuration PC using the "Search
button, the file name is displayed here.
● Search
Searches the file system of the configuration PC for a configuration file saved there that is
intended to be loaded on the RTU.
● Load on device
Loads the configuration file shown under "File" on the RTU.
Note
On completion of loading, the configuration data of the loaded configuration file is used
immediately by the RTU.
● Load from SD card
Loads the configuration file located on the SD card on the RTU.
Note
On completion of loading, the configuration data of the loaded configuration file is used
immediately by the RTU.
Note the behavior of the RTU when there are several configuration files on the SD card,
refer to the section "Startup of the RTU with configuration files" below.
RTU3030C
Operating Instructions, 09/2017, C79000-G8976-C382-04
Configuration (WBM)
4.11 Maintenance
99
Advertisement
Table of Contents
