Table of Contents
Advertisement
Configuration (WBM)
4.11 Maintenance
● Load on device
By clicking the button, download the selected logging file to the RTU.
● Standard settings
Loads the default logging file preset in the factory instead of a file for logging made
available by Product Support.
● Delete
Deletes a no longer required logging file from the RTU.
After deleting the logging file, logging is disabled again.
Enable logging
After loading the logging file, logging must be actively enabled.
● Enable logging and save the file on the SD card
By enabling the option logging is started as soon as you click the "Apply" button.
The log file is saved on the SD card and updated during operation if relevant events
occur.
Use of the logging
You should only use logging of events. If you have problems with the RTU that you cannot
solve yourself.
Note
Protecting the SD card by disabling logging
To avoid shortening the working life of the SD card too much, logging should be disabled
during normal operation of the RTU.
When logging is enabled, during runtime the RTU continuously saves information about
important events that have occurred. The saved data contains information on the
configuration, active procedures and error situations.
The data is saved on the SD card in a log file with the name "support.bin". The information in
this file is encrypted and can only be read by Siemens Industry Online Support. On
completion of logging sent the log file back to your contact at Siemens Industry Online
Support.
106
Operating Instructions, 09/2017, C79000-G8976-C382-04
RTU3030C
Advertisement
Table of Contents
