Table of Contents
Advertisement
Application and functions
1.2 Configuration examples
● Communication with the control room
If a communications partner is available in the master station, the RTU can send process
data to the control room. The data is transferred either via the mobile wireless service
GPRS or UMTS or via LAN (optionally with an external router).
● Telecontrol protocols
For communication with the master station, the RTU supports the following protocols:
– TeleControl Basic
– SINAUT ST7
– DNP3
– IEC 60870-5-104
You will find detailed information about the protocols in the section Communications
services (Page 23).
Configuration examples
You will find configurations of the RTU in the section Configuration examples (Page 14).
Configuration and programming of the RTU in the WBM
Configuration
You configure the parameters of the RTU itself, its inputs and outputs, control functions and
communication parameters conveniently in the Web Based Management (WBM). The WBM
consists of Web pages stored on the RTU. From a configuration PC you connect to the
WBM.
Programming
You program in the WBM with the following actions:
● Keyboard entries
● Selection of options in drop-down lists
● Enabling check boxes
● Working with buttons ("Apply", "Add", "Load", "Search" etc.)
1.2
Configuration examples
Below, you will find configuration examples for applications of the RTU3030C.
You will find references to the configuration of individual communications functions in the
section Communications services (Page 23).
You will find a diagram of the configuration of the configuration PC that accesses the WBM
of the RTU using HTTP and OpenVPN in the section Establishing a connection to the WBM
of the RTU (Page 81).
14
Operating Instructions, 09/2017, C79000-G8976-C382-04
RTU3030C
Advertisement
Table of Contents
