Start Page; Overview - Siemens SIMATIC RTU3030C Operating Instructions Manual

4.8

Start page

4.8.1

Overview

After logging in to the WBM, the start page appears.
In the title bar of the Browser tab, the station name of the RTU is displayed that you
configure in "System".
In the title bar of the window apart from the user name (left) and the general buttons for the
WBM (right) you will find the following information:
● Next communication cycle (configured / assigned)
– Configured communication cycle (interface)
– Assigned communication cycle (interface)
● Next SMS check in sleep mode
See section Operating modes (Page 138) for information on this.
On the left there is the navigation area with the main levels of the WBM.
At the bottom right there are the tabs "Overview" and "Status". Change to the various tabs by
clicking the tab name.
Figure 4-3 Start page of the WBM with the open tab "Overview"
RTU3030C
Operating Instructions, 09/2017, C79000-G8976-C382-04
The next communication cycle specified in the WBM configuration, see section
Operating modes (Page 138), and in brackets the activated interface.
The next communication cycle assigned by a TeleService SMS message, see section
Wake-up call / wake-up SMS (Page 192), and in brackets the activated interface.
Configuration (WBM)
4.8 Start page
87