Table of Contents
Advertisement
Connecting up, installation, commissioning
3.5 Installing an RTU
Installation location
NOTICE
Installation location - Dependency of the temperature range
The module must be installed so that its upper and lower ventilation slits are not covered,
allowing adequate ventilation. Above and below the device, there must be a clearance of 25
mm to allow air to circulate and prevent overheating.
Remember that the permitted temperature ranges depend on the position of the installed
device. You will find the permitted temperature ranges in the section Technical data
(Page 261).
Installation of the rack
Horizontal installation of the rack (DIN rail)
Vertical installation of the rack (DIN rail)
58
Installation position of the RTU
Operating Instructions, 09/2017, C79000-G8976-C382-04
RTU3030C
Advertisement
Table of Contents
