Onboard Drive Interface (C230-2, C240) - Siemens SIMOTION C 230-2 Operating Instructions Manual

Interfaces

4.5 Onboard drive interface (C230-2, C240)

Signal type
O - signal output
I/O - signal input/output
VO - voltage output
4.5 Onboard drive interface (C230-2, C240)
Connector to drive unit
Drive units with an analog interface (±10 V) or stepper motor power units with at least one clock
pulse input and direction input can be connected to the 50-pin Sub-D socket X2. Any hybrid
configuration can be used for up to four drives.
In addition, the C230-2 and C240 provide one enable signal per axis.
With the C240, this interface (X2) can also be used for standard outputs:
• 4 analog outputs
• 4 digital outputs
Position of the connector
The following figure shows the installation position and the designation of the connector on the
module.
Figure 4-5
Connector pin assignment
Onboard drive interface (servo interface, 4 axes)
50
Position of the X2 connector
Operating Instructions, 11/2022, A5E33441428B
SIMOTION C