Chrysler Sebring 2004 Service Manual page 1101

9 - 174 ENGINE 2.7L DOHC
CAMSHAFT(S) (Continued)
(4) Insert the compressed and locked camshaft
chain tensioner in-between the camshafts and chain.
(5) Rotate the cams so that the plated links and
dots are facing the 12:00 O'clock position (Fig. 29).
(6) Install cams to cylinder head. Ensure that
rocker arms are correctly seated and in proper posi-
tions.
(7) Install camshaft bearing caps. Ensure that
bearing caps are installed in same position as
removed.
(8) Tighten cam bearing cap bolts gradually in
sequence shown in (Fig. 26) to 12 N·m (105 in. lbs.).
(9) Install secondary chain tensioner bolts and
tighten to 12 N·m (105 in. lbs.).
(10) Remove locking pin from secondary tension-
ers.
(11) Measure camshafts end play. (Refer to 9 -
ENGINE/CYLINDER HEAD/CAMSHAFT(S) - STAN-
DARD PROCEDURE)
(12) Install the primary timing chain. (Refer to 9 -
ENGINE/VALVE TIMING/TIMING
AND SPROCKETS - INSTALLATION)
Fig. 29 Camshaft Chain Timing
1 - PLATED CHAIN LINKS
2 - CAMSHAFT TIMING MARKS (DOTS)
CYLINDER HEAD COVER -
LEFT
REMOVAL
(1) Disconnect negative battery cable.
(2) Remove upper intake manifold (Refer to 9 -
ENGINE/MANIFOLDS/INTAKE
REMOVAL).
(3) Disconnect electrical connectors from ignition
coils and capacitor. Reposition electrical harness.
stud.
from cylinder head cover studs. Reposition electrical
harness.
tor.
30).
NOTE: Cylinder head cover attaching bolts are cap-
tured to the cover.
CAUTION: Make certain the double ended studs in
the center of the cylinder head cover are loose
before attempting to remove cover (Fig. 30).
BELT/CHAIN
1 - DOUBLE ENDED STUDS
2 - BOLTS
INSTALLATION
faces. Inspect and replace gaskets as necessary (Fig.
31).
fasteners. Verify that all double-ended studs are in
MANIFOLD -
the correct locations as shown in (Fig. 30).
double-ended studs to 12 N·m (105 in. lbs.).
(4) Remove ground strap from cylinder head cover
(5) Disconnect electrical harness retaining clips
(6) Remove fastener attaching ignition coil capaci-
(7) Remove ignition coils.
(8) Loosen all cylinder head cover fasteners (Fig.
(9) Remove cylinder head cover.
Fig. 30 Cylinder Head Cover Fasteners
(1) Clean cylinder head cover and both sealing sur-
(2) Install cylinder head cover and hand start all
(3) Tighten cylinder head cover attaching bolts and
(4) Install ignition coils.
JR