Table of Contents
Advertisement
D.4.2 Configure the Computer
The computer must be configured with the correct network settings that were used for the
Modem. Contact your network administrator for an IP address mask and modem, server and
router IP addresses valid for your network.
To recognize a subnet, each system in the subnet must have the same subnet mask. Set this
field after the changes are made to the Modem. See Figure D-6.
1. Configure the computer with the new subnet addresses.
a. Do a ping test to make sure there is communication between the modem and the
b. If communication is functioning correctly, replies from the modem show on the
c.
2. Open the Web browser on the computer. See Figure D-2.
3. Enter the new IP Address assigned by the network administrator.
4. Press Enter.
Appendix D
computer.
Example: ping 192.168.0.238
computer screen, along with the time it took to respond. Skip to Step 2.
If unsuccessful, make sure of these items:
i. The cables are secure.
ii. The Link Light is lit.
iii. The IP Address matches the Modem's IP Address.
iv. The Server and Modem are on the same subnet.
DMD1050TS Satellite Modem Board
D–6
Revision 1
MN-DMD1050TS
Advertisement
Chapters
Table of Contents
