Unit Info Menu [ I ]; Table 9-10. Unit Information Options - Comtech EF Data DMD1050TS Installation And Operation Manual

9.2.7 Unit Info Menu [ I ]

See Appendix H for information about the TRANSEC Module firmware update process.
The Unit Information Menu shows information so that you can make sure the correct firmware is
loaded.
Menu
Options/Fields
[Bootrom Info]
[Bulk 1 Info]
[Bulk 2 Info]
Boot From
Reboot
TRANSEC Module SSH CLI Operation
Figure 9-12. Unit Info Menu Example

Table 9-10. Unit Information Options

Entry
[RO]
Shows the bootrom firmware.
[RO]
Shows the firmware version loaded into Slot 1.
[RO]
Shows the firmware version loaded into Slot 2.
B Select the firmware boot source for modem operations:
0: Newest. This selects the most current firmware residing in either Slot 1 or
Slot 2, automatically.
1: Slot 1. This selects the firmware in the Slot 1 location.
2: Slot 2. This selects the firmware in the Slot 2 location.
Note: If the Boot From selection is changed, you must reboot the modem so that
the firmware selection is loaded for operation.
R Reboots the modem. When selected, you see this prompt:
This action will reboot the TRANSEC module.
Are you sure? (Y/N)
Enter Y or N. If Y is entered, the reboot process begins by closing the SSH CLI.
THIS MODEM WILL REBOOT
IN FIVE SECONDS!
BOOTING MODEM...
...PLEASE WAIT
INITIALIZING MODEM...
Once the modem reboots, you must start a new SSH CLI session to resume use of
this interface.
DMD1050TS Satellite Modem Board
Description
9–15
Revision 1
MN-DMD1050TS