Alarms | Common Page
TransecPwrTest
VOLTAGE
+1.5V RX Supply
-1.5V TX Supply
+3.3V Supply
+5V Supply
+12V Supply
-12V Supply
+20V Supply
RESET LATCHED
ALARMS
Web Browser
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
Current
•
Latched
•
Masked (checkmark)
•
Unmasked (no check)
•
7–61
DMD1050TS Satellite Modem Board
Displays the results of the Power On Self Test (POST)
done by the TRANSEC module when installed.
This shows if the measured voltage of the 1.5 Volt Rx
power bus that is inside the modem is xxx.
This shows if the measured voltage of the 1.5 Volt Tx power
bus that is inside the modem is xxx.
This shows if the measured voltage of the +3.3 Volt power
bus that is inside the modem is xxx.
This shows if the measured voltage of the +5 Volt power
bus that is inside the modem is xxx.
This shows if the measured voltage of the +12 Volt power
bus that is inside the modem is xxx.
Displays the measured voltage of the -12 Volt power bus
located inside the modem.
This shows if the measured voltage of the +20 Volt power
bus that is inside the modem is xxx.
Use to reset (Clear) all Latched Alarms.
Revision 1
MN-DMD1050TS